Quick Installation Guide

3 1GE+3FE+WIFI EPON ONU Quick Installation Guide_V2.0
LED Mark Status Description
Power POWER
On The device is powered up.
Off The device is powered down.
Registration PON
On The device is registered to the PON system.
Off Device is not registered to the PON system.
Blink Device registration is incorrect.
Optical signal LOS
Blink Device does not receive optical signals.
Off Device has received optical signal.
WiFi WiFi
On WiFi is working
Off WiFi is not working
WPS Pair ON WIFI allow one key join
Interface
LAN1
LAN2
LAN3
LAN4
On Port is connected properly (LINK).
Off Port connection exception or not connected.
Blink Port is sending or/and receiving data (ACT).
Table 1 Panel Lights
1.4 Interface/button Panel
Figure 4 Interface/button Panel
Name Function
PON
Connect to OLT by SC type fiber connector, single mode optical fiber
cable.
LAN
Connect PC or other devices with Ethernet port by Cat5 cable, RJ-45
connector.
RST
Press RST button over 10 seconds, onu restores factory default and
reboot.
POWER Connect with power adapter. DC 12V, 1A.
Pair Press down WiFi pair button to begin pairing.
WiFi Press down WiFi turn on/off button to enable/disable WiFi function.
Table 2 Interface/button Panel