Quick Installation Guide
Table Of Contents
3 2LAN+1POTS+WiFi(dual band) Dual Mode HGU Quick Installation Guide_V2.0
Registration
PON
On
The device is registered to PON system.
Off
Device is not registered to PON system.
Blink
Device is registering.
Optical
signal
LOS
Blink
Device does not receive optical signal.
Off
Device has received optical signal.
WAN
WAN
On
WAN connection is up.
Blink
Data passing WAN connection.
Off
WAN connection is down.
Ethernet
LAN1
LAN2
On
Port is connected properly.
Off
Port connection exception or not connected.
Blink
Port is sending or/and receiving data.
Wireless
2.4G
5G
On
WiFi is turned on.
Off
Device is power off or WiFi is turned off.
Blink
WiFi turned on and with ongoing data transmission.
Pots
PHONE
On
Device has registered to soft-switch, but without
ongoing data transmission.
Off
Device is power off or not registered to soft-switch.
Blink
The port is with ongoing data transmission.
Table 1 Panel Lights
1.4 Interface/button Panel
Figure 4 Interface/button Panel
Name
Function
PON
Connect to OLT by SC type fiber connector, single mode optical fiber
cable.
FXS
Connect the telephone with FXS port by telephone wire.
LAN1/2
Connect PC or other devices with Ethernet port by Cat5 cable, RJ-45
connector.
DC 12V
Connect with power adapter.
ON/OFF
Power supply switch.
RST
1. Press RST button over 10 seconds, onu restores factory default and
reboot.
2. Press RST button quickly, onu reboots.