User's Manual

Galaxy G6
- 114 -
Multipath error: the positioning error caused by the interference between two or
more radio signal propagation path.
Observing session: the use of two or more receivers at the same time to collect GPS
data period.
Pseudo Range: GPS receiver in the time required to copy the code aligned with the
received GPS code offset and multiplied by the speed of light to calculate the
distance. This time offset is the difference between the signal reception time (time
series of the receiver) and the signal emission time (satellite time series).
Receiver channel: GPS receiver RF mixer and IF channel, can receive and track
satellites two carrier signals.
Satellite configuration: the configuration status of the satellite with respect to a
specific user or a group of users within a specific time.
Static position: do not consider the point of measurement of the movement of the
receiver.
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:(1) This device may not cause harmful interference, and (2)this device must
accept any interference received, including interference that may cause undesired
operation.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. The antenna(s) used for this transmitter must be installed and operated
operating to provide a separation distance of at least 60 cm from all persons and must not
be collocated or operating in conjunction with any other antenna or transmitter.
Installer must ensure that 60cm separation distance will be maintained between the device
(excluding its handset) and users.
Caution: The user is cautioned that changes or modifications not expressly
approved by theparty responsible for compliance could void the user's authority to
operate the equipment.