User's Manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the

the following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including interference

that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation.

This equipment generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

The device for operation in the 5180 MHz is only for indoor use to reduce the

potential for harmful interference to co-channel mobile satellite systems.

4. FCC Statement

FCC RF Radiation Exposure and SAR Statements SAR Statement The Wireless

Screen Mirroring has been tested for body-worn Specific Absorption Rate (SAR)

compliance. The FCC has established detailed SAR requirements and has

established that these requirements. RF Exposure Information The radio module

has been evaluated under FCC Bulletin OET 65C (01-01) and found to be

compliant to the requirements as set forth in CFR 47 Sections, 2.1093, and

15.247 (b) (4) addressing RF Exposure from radio frequency devices. This

model meets the applicable government requirements for exposure to radio

frequency waves. The highest SAR level measured for this device was 0.085

W/kg.

5. RF Exposure Statement