User's Manual

User Manual

SAFETY NOTICE

1. Flush-mount only into a UL/ETL/CE certified plastic junction box and switch panel cover. The

minimum size should be 65*65*42mm, minimum Volume is 180cm

2. Use Copper Conductors Only.

3. CAUTION - Risk of Electric Shock - More than one disconnect switch may be required to

de-energize the equipment before servicing.

4. WARNING-This device shall not be used in combination with a wall switch controlling a

receptacle.

1-year Limited Warranty

We warrant this product to be free from defects in material and workmanship under normal and proper use for one year from

purchase date of the original purchaser. We will, at its option, either repair or replace any part of its products that prove

defective by reason of improper workmanship or materials. THIS LIMITED WARRANTY DOES NOT COVER ANY DAMAGE TO THIS

PRODUCT THAT RESULTS FROM IMPROPER INSTALLATION, ACCIDENT, ABUSE, MISUSE, NATURAL DISASTER, INSUFFICIENT OR

EXCESSIVE ELECTRICAL SUPPLY, ABNORMAL MECHANICAL OR ENVIRONMENTAL CONDITIONS, OR ANY UNAUTHORIZED

DISASSEMBLY, REPAIR OR MODIFICATION. This limited warranty shall not apply if: (i) the product was not used in accordance

with any accompanying instructions, or (ii) the product was not used for its intended function. This limited warranty also does

not apply to any product on which the original identification information has been altered, obliterated or removed, that has not

been handled or packaged correctly, that has been sold as second-hand or that has been resold contrary to Country and other

applicable export regulations.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.