Operating Instructions

6
Installation Instructions
• The vehicle must meet the voltage,
current and power that required,
please check the conditions before
installation;
• The installation should be done while
the battery of the vehicle is
disconnected;
• To ensure that the product has been
fitted with a fuse;
• The installation of the product should
not affect the safety of the operation
and function of the vehicle.
• The installation position should not
block the driver's sight and should not
be on the place that the brake,
steering wheel, seat belts, airbags and
other vehicle safety equipment should
be;
• Please confirm the matching condition
of the vehicle interface before install
this product, use the appropriate
patch plug if the interface is not
matched.
• Please be familiar with the connection
of the vehicle before installation,
confirm the position of the piping,
electrical wiring, fuel tank and other
vehicle system components. Do not
touch or damage these components
and avoid the exposure of wires that
may cause corrosion, leakage, etc.;
• Please do not conduct the installation
in place of condensation, drench water
sites, high humidity, containing dust
and oil smoke. If water, moisture, dust
and oil smoke enter the product, it
may cause smoke, fire or failure.
• Please do not move or disassembled
the existing screws, nuts, bolts, clips,
connecting fixed appliances,
accessories and so on, do not change
or remove vehicle incidental contact
system and wire clip, otherwise it
may impair the function of
automobile safety;
• In order to avoid the occurrence of
fire damage to the product or
vehicle, please do not allow the
existing power supply circuit
overload when power the product;
Please be sure that the power wires
have insulation treatment and install
with fuses, circuit breakers and
relays.
• Please use non conductive tape in
insulation treatment, wrap the ends
of the wire and unused wire; correct
insulating treatment can avoid the
occurrence of electric arc, electric shock
or fire. In order not to impede the brake
pedal, gearbox and steering wheel, plastic
belt could be used to fix the wires. Please
do not make the wires contact high
temperature surface, the heat can easily
cause damage to the wires and lead to
short circuit, arc or fire;
• Please fix the wire on the electric chair or
other parts of vehicle where will not lead
to the scratch or damage of wire. In
addition, the wire should be fixed in the
hidden place as far as possible, it will
make the environment inside the vehicle
beautiful.
• Please do not block the airflow vents,
otherwise it may cause internal overheat
and fire;
• After the installation is completed, please
check the wire connection of the vehicle,
then run all functions, including lights,
speakers, stereo, reversing operation and
other electrical systems and ensure that
the vehicle function is normal and can be
used safely.
ENGLISH