User's Manual

10
Function：Check L-grade power indicator
Example： PWRL show“0.500”
3.2.26 PWRH
Function：Check H-grade power indicator
Example：PWRH show“1.000”
3.2.27 SPRT
Function：Check the supported protocols
Example：SPRT show
“TRIMTALK;TRIMMK3;SOUTH;TRANSEOT;GEOTALK;GEOMK3;SATEL; HITARGET; PCCEOT; PCCFST;
SATEL_ADL; PCCFST_ADL”
3.2.28 SBAUDRATE
Function：Check air baud rate(unit：bps)
Example：SBAUDRATE show“4800; 9600; 19200”
3.2.29 TEMP
Function：Check current temperature(℃)
Example：TEMP show“36.808”
3.2.30 U
Function：Check present supply voltage.
Example：U show“3.288”
3.2.31 RPT【parameter】
Function：Set relay mode
Parameter：ON/OFF
Example：Enable relay function “RPT ON”, show “PROGRAMMED OK”
3.2.32 RPT
Function：Check relay mode
Example：RPT show “RPT OFF”
3.2.33 FEC【parameter】
Function：Set FEC function switch
Parameter：ON/OFF
Example：Enable FEC function “FEC ON” show “PROGRAMMED OK”
3.2.34 FEC
Function：Check FEC function state
Example：FEC show “FEC ON”
3.2.35 RIP 【parameter】
Function：Set protocol correction on output (only for TRANSEOT、TRIMTALK、TRIMMK3)
Parameter：ON/OFF
Example：Enable RIP function “RIP ON” show “PROGRAMMED OK”
3.2.36 RIP
Function：Check RIP function state
Example：RIP show “RIP ON”
3.2.37 CSMA 【parameter】
Function：Set carrier to sense multiple access
Parameter：ON/OFF
Example：Enable CSMA function “CSMA ON” show “PROGRAMMED OK”
3.2.38 CSMA
Function：Check CSMA function state
Example：CSMA show “CSMA ON”
3.2.39 ID 【parameter】
Function：Set ID number for call sign
Parameter：16-digit ID number (if less than 16 digits, 0 to16 digits will be added automatically
in front of ID)
Example：ID 123 show “PROGRAMMED OK”
3.2.40 ID