User's Manual

9
Example：CHANNEL show “CHANNEL 1”
3.2.11 CHANNELTABLE【parameter 1】【 parameter 2】
Function：Set frequency of channel
Parameter：parameter 1 (channel): 1~16, parameter 2 (frequency): 410.0 – 470.0 902.4 – 9285
Example：CHANNELTABLE 1 414.015 show “PROGRAMMED OK”
3.2.12 CHANNELTABLE 【parameter】
Function：Check frequency of channel
Parameter：1~16
Example：CHANNELTABLE 1 show “CHANNELTABLE 1 414.015000”
3.2.13 PRT 【parameter】
Function：Set current protocol type
Parameter choice ： TRIMTALK 、 TRIMMK3 、 SOUTH 、 TRANSEOT 、 GEOTALK 、 GEOMK3 、
SATEL、HITARGET、PCCEOT、PCCFST、SATEL_ADL、PCCFST_ADL
Example：PRT TRIMTALK show“PROGRAMMED OK”
3.2.14 PRT
Function：Check current protocol type
Example：PRT show“PRT TRIMTALK”
3.2.15 SREV
Function：Check current software version
Example：SREV show the current software version“G001.02.07”
3.2.16 SER
Function：Check the serial number
Example：SER show“SN:TRM218030242”
note：If UHF has never set the SN with no.14 command, so only show the “SN:”
3.2.17 CTIME
Function：Set the serial number
Parameter choice：Less than 16 numbers of ASCII
Example：SER TRU201-006 show“PROGRAMMED OK”
note：Serial number is the only remark for the UHF, so it’s forbidden to change the serial
number by software.
3.2.18 FLOW
Function：Check the lower limit of UHF frequency.
Example：FLOW show“FLOW 410”
3.2.19 FUPP
Function：Check the upper limit of UHF frequency.
Example：FUPP show“FUPP 470”
3.2.20 SBAUD 【parameter】
Function：Set baud rate of Communication interface.
Parameter choice：9600、19200、38400、57600、115200
Example：SBAUD 38400 show“PROGRAMMED OK”
3.2.21 SBAUD
Function：Check baud rate of Communication interface (unit:bps)
Example：SBAUD show“SBAUD 38400”
3.2.22 BOOTVER
Function：Check current BOOT version
Example：BOOTVER show“15.09.23”
3.2.23 HWVER
Function：Check hardware version
Example：HWVER show“V1.0”
3.2.24 MODEL
Function：Check model.
Example：MODEL show“TRM101”
3.2.25 PWRL