1.press the scanner switch and two beep sound,indicating the power is on. Meantime the blue light is flickering (This means the scanner is waiting for connection with Bluetooth terminals.
11.When charging the red light is on indicating the scanner under charging, red light is off indicating full reading code indicator.) 12.The scanner will shut down after pressing switch 10 seconds.
IV Other Setting 1.
3.Data Transfer Speed Settings Reveal Conceal 25 bits / second 4.
5.Sleeping Time Settings Open Sleeping Time Setting 20S min 60S 30S min min 6.
Enter into Settings V Restore Factory Settings Restore Factory Settings Note: first read the “Enter into Settings” then read the ” Restore Factory Settings” and finally read the “Exit Settings”. It can make all the previous settings back to factory settings.
Enter into Settings (VI)Barcode Enable And Forbid Read All Types of Barcode Forbid to Read All Types of 2D Barcode Forbid To Read All Types of 1D Barcode Enable to Read All Types of 2D Barcode 8 Enable to Read All Types of 1D Barcode Exit Settings
Enter into Settings VII Line Feed Suffix Setting Add Line Feed Suffix Enable Suffix Note: first read “Enter Into Settings” then read” Enable Suffix” ,“Add Line Feed Suffix” and last read” Exit Settings”, line feed can be added.
Enter into Settings VIII Add Blank Lines Add Blank Lines Enable Suffix Note: first read “Enter Into Settings” then read” Enable Suffix” ,“ Add Blank Lines ” and last read” Exit Settings”,blank line can be added.
Enter into Settings IX Set the prefix Not Reveal Prefix Reveal Prefix Add Prefix Exit Settings 11
Enter into Settings X Set the suffix Not Reveal Suffix Reveal Suffix Add suffix Exit Settings 12
XI Parameters code 0 1 2 3 4 5 6 7 13 8
9 A C D F Save Settings C a n c e l se t a st r i n g o f da t a B E Cancel the current Settings C a n c e l t h e cu r r e n t Se t t i n g s 14 Exit Settings
XII Parameter barcode and corresponding representing characters table.
This scanner with paired Bluetooth adapter usage(for referred) (*A external bluetooth adapter can be prepared and used as following steps.) Note: If don’t use the Bluetooth adapter can ignore the follow content.
above two .
Picture(1) 3.Installation completely will appear the interface as show below, click “Yes” restart the computer.
Picture(4) Picture(5) Match Settings Picture(6) 23 Bluetooth HID
About the Warranty 1.Since you buy our product with this card,you can enjoy the service of one year repair and lifelong maintenance for the rubber and plastic parts of the barcode scanner,6 months repair service for the battery and the charger,and 3 months repair service for the data cable.During the repair period,the maintenance of the product is free.Expire the warranty, and maintenance cost; we will charge the replaced components . 2.
Distributor Information User Information Name Address Zipcode Tel Name Address Zipcode Operator Signature Distributor Seal Email Quantity Accessories Name Scanner Adapter and CD USB Charge Cable Manual 31
Maintenance Record Date Fault Maintenance Operator Description Record Barcode Reader Warranty Card Part No. Serial No. Purchase Date Please make sure to read the instructions about maintenance carefully at the back of the card. Fill out various data above carefully and the file vaild only if it is signed with the offical of the authorized dealer.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
