Instruction Manual

13 / 16
2. If no atomic signal is still received, the time setting
must be made manually.
Read the detailed manual for more information about
manual time and alarm setting (see download information
on page 2).
10 Alarm setting
Alarm time setting
1. In normal display mode, press SET button to switch to
alarm time display (AL).
2. Press and hold SET button for approx. 3 seconds to
enter alarm time setting mode.
3. Digits to be set are flashing.
4. Press UP or DOWN button to change the value.
5. Press SET button to confirm and continue to the next
setting.
6. Settings order: hours > minutes
7. Finally press the SET button to save the settings and
exit the setting mode.
Enable/disable alarm
8. In normal display mode, press SET button to switch to
alarm time display (AL).
9. Press DOWN button to enable the alarm. The
symbol
will be displayed.
10. Press DOWN button again to disable the alarm. The
symbol will disappear from the display.