Instruction Manual

12 / 16
8. Wait until the indoor temperature is displayed on the
base station.
NOTICE! When switching from mains power supply
to battery power supply or vice versa, the power
supply is being disabled for a short moment for
technical reasons. Exception: permanent battery op-
eration.
Remote sensor
9. Remove the battery compartment cover.
10. Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
11. Set the channel selector switch to the desired channel.
NOTICE! This weather station can be operated with
one or more remote sensors. Each remote sensor
being connected must be operated on a dierent
channel. If only one remote sensor is connected, it
should be operated on channel 1.
12. Replace the battery compartment cover.
9 Automatic time setting
After the power is restored, the unit automatically searches
for the atomic signal. It takes about 3-8 minutes to complete
this process.
If the atomic signal is received correctly, the date and time
are set automatically and the reception symbol is displayed.
If no atomic signal is received, proceed as follows:
1. Press the DOWN button for approx. 2 seconds to initi-
ate the reception of the atomic signal again.