User's Manual

User manual
Guangzhou Andea Electronics Technology Co., Ltd. 8/26
http://www.gzandea.com
shown in the figure below:
Figure 10 R-Tool connection interface
Choose "COM" from [Communication] under [Search parameters]. Choose "All"
for [COM name], set [Baud rate] as 38400, set [Frame] as 8E1, and set [address] as
255，and then click the search button to search for the device. After the device is found,
the device information will be automatically displayed in the "Discovered Devices" list,
as shown in the figure below:
①
②
③
④
Figure 11 Operation steps when use RS232 interface connection
As shown in the picture above (Step 4), click the “Start” button to enter the main
interface of the configuration software.