User's Manual

User Manual
Andea Electronics http://www.gzandea.com Page 17 Total 44 Pages
Table 4 Description for Anti-theft Alarm Parameters Setting
Setting Options
Description
Detection
Method -
Way to
check if
book in
library
Detect EAS bit
Detect the EAS status of the tag. When using the tag
EAS function for alarm detection, you need to turn
on the EAS function of the tag to indicate that it is
an illegal tag. At this moment, the tag can be
detected and alarmed through the gate.
Detect AFI value
Detect and match the AFI value of the tag. If the
AFI value of the tag is the same as the AFI value set
by the gate, an alarm is issued. Default: Use this.
Note: When the gate detection AFI value is set to
00, all tags will alarm and 00 means no tags will be
filtered.
Detect EAS and AFI
Detect both EAS and AFI.
EAS
EAS Command 1
EAS command type. It is used to detect the EAS
status. You must select the correct EAS command
according to different tag types to correctly detect
the EAS status. It is enabled by default. Default
type: NXP Command, also optional: FM or ST type
EAS Command 2
Disabled by default, default type: NXP Command,
also optional: FM or ST type
EAS Command 3
Disabled by default, default type: NXP Command,
also optional: FM or ST type
AFI
AFI 1
Enabled by default, default AFI value: 00
AFI 2
…
AFI 4
Enabled: Disabled by default
Default AFI value: 00
Memory
Bank
Option
Memory area
None: Do not read data from UID and USER area
UID area: only read tag UID area (default setting)
USER area: only read tag USER area
UID and USER area: read UID and USER area
User
Area
Start Pos
Offset byte of the barcode data in the data block, the
default value is 0x00