User's Manual

User Manual
Andea Electronics http://www.gzandea.com Page 14 Total 44 Pages
5.3 Parameters Configuration
After searching the online gates, click [Configuration] to configure the gate's
IP address, alarm mode, alarm conditions, RF power and other parameters. In this
gate system, the parameter setting only needs to be set at the first use. After the
setting is completed, all parameters can be configured synchronously:
Figure 10 Interface for Configuration
Note: After changing configuration parameters, it is must to click [Write] then
[Save] button, otherwise the setting is unsuccessful.
5.3.1 Communication Setting
Click [Communication], you can set the serial port communication parameters
and network communication parameters of the device. After saving, it needs to
restart the device to take effect.