User's Manual

User Manual
Andea Electronics http://www.gzandea.com Page 12 Total 44 Pages
third IP of the gate as same as those on the computer, then search again.) Click
[Select] to return to the [Search Devices], select the port number as 6012 and
click [Search]. After that, click the [Start] to enter the configuration interface:
Figure 7 Interface for Successfully Searching for Devices
5.2 Search Gate
After the software and the device are successfully connected, enter the
R-TOOL software setting interface, click [Search Gate] to search for the online gate,
click [Save] after the searching is completed. Then you can perform synchronous
configuration when configuring the gate parameters.
Note: When each gate is used for the first time, or after the gate positions
are changed, or added or reduced the , a search operation is required to make
the gate system for normal using. This system can also be configured before
shipment according to the customer's needs which can be confirmed with our sales
staff.
Steps: Click [Search Gate] → click [Search Again] → search interface