User's Manual

User Manual
Andea Electronics http://www.gzandea.com Page 11 Total 44 Pages
① Select [Net] communication
② Click to enter into [Discovery IP] interface
1、Click [Start]
to search device
2、After the gate is found, the IP address of the gate will
be shown at above list. Select the gate to connect.
3、Click [Select] to return to the
search device interface
Notice：
After IP searching, we need to check if the gate IP is
in the same network segment. If not, we need to modify
the [LAN Option]：
A. Click [Stop] then select the gate in the IP list to
modify.
B. Modify the first third [New IP], [New Mast] and
[New Gate] same as computer.
C. Click [Modify LAN] to confirm the modification.
D. Research the gate according to step 1, 2, 3.
Figure 6 Software Interface Using LAN Port
Click [Start], the gate IP address and other information will be displayed in the
IP list, select the IP address to connect (Set the sub-net mask, gateway and the first