User's Manual

User Manual
Andea Electronics http://www.gzandea.com 40/44
that meets the alarm conditions, but there is no alarm output. Check
whether the sound and light alarm setting is set to "Do not trigger sound
and light alarm" or to turn off the buzzer. Section 5.3.2 Anti-theft Alarm
Parameters, otherwise some circuit failures (component failure or damage)
should be considered.
②
①
Figure 38 Check Alarm Parameters
(2) The tag detection indicator does not light, you need to check whether
the gate is offline or the system is set to the anti-theft detection hanging.
Solution:
① Check whether the error indicator of the control center is red. If it is
red, check the "System Error Flag" under the control command
function to see what kind of failure occurs and set to “Resume
Anti-theft”, see section 5.4 Control Command;