User's Manual

User Manual
Andea Electronics http://www.gzandea.com 13/44
Figure 8 Interface for Successfully Searching for Devices
5.2 Search Gate
After the software and the device are successfully connected, enter the
R-TOOL software setting interface, click [Search Gate] to search for the online gate,
click [Save] after the searching is completed. Then you can perform synchronous
configuration when configuring the gate parameters.
Note: When each gate is used for the first time, or after the gate positions
are changed, or added or reduced, a search operation is required to make the
gate system for normal using. This system can also be configured before
shipment according to the customer's needs which can be confirmed with our sales
staff.
Steps: Click [Search Gate] → click [Search Again] → search interface
displays all connected gates → click [Save] to complete the search of gates → click
[Current Status], all gates are shown online for normal use.