Robot vacuum cleaner
Tips Please read through this manual before using the product, and keep it properly.
Safety Instructions Restrictions on use Plastic bags are dangerous! Keep plastic bags out of the reach of infants and children to avoid suffocation. This product is designed only for cleaning the floor in the home environment. Do not use it outdoors (such as open balcony), in places other than the floor (such as sofa), or in commercial or industrial environment. Do not use the product in hanging places (such as duplex floor, open balcony, top of home) without any protective rail.
Battery and charging Even if the product has been seriously damaged, it is strictly forbidden to burn the product, because the product battery may cause explosion. Do not use the batteries, chargers and dust collection charging piles of any third party. Do not disassemble, repair or refit the battery and dust collection charging pile without permission. Do not place the dust collection charging pile close to heat sources (such as radiator).
Packing List Sweeping and mopping robot Mop cloth support Mop cloth Cleaning knife Instructions Dust collection charging pile Disposable mop cloth �� � Quick start uide Dust bag � Tips: The illustrations of products, accessories, user interfaces and so on in the Instructions are schematic diagrams, which are for reference only. Due to the update and upgrading of the product, the real product may be slightly different from that shown in the schematic diagrams. Please refer to the real product.
Accessories installed on the sweeping and mopping robot Main brush Two-in-one water tank Main brush cover Side brush Accessories installed on the dust collection charging pile Dust bag handle Dust bag (� dust collection charging pile has been installed) Tips: the dust bag is consumable, and cannot be reused. Please replace it regularly.
Basic Parameters Sweeping and Mopping Robot Product name Product model Product dimensions Robot vacuum cleaner HD-STYTJ-B��、HD-STYTJ-W�� ��� × ��� × ���mm Input of sweeping and mopping robot ��V Operating voltage of sweeping and mopping robot ��.�V Rated power of sweeping and mopping robot ��W �.�A Battery type Lithium ion battery pack Wireless connection Wi-Fi IEEE ���.��b/g/n �.
Instructions on Environmental Protection The chemicals contained in the lithium-ion battery of the product will pollute the environment. Please remove the battery before scrapping and send it to a professional battery recycling station for centralized disposal. Steps for removing the battery. *The following information is only applicable to the discarding of the sweeping and mopping robot and not to daily operation �.
Product Introduction �. Machine Recharge/fixed-point cleaning On and off/global cleaning Short-press to start the recharge Press and hold for � seconds to start the fixed-point cleaning Short-press to start the global cleaning/pause Press and hold for � seconds to turn on or off the machine Tips: In the course of recharging, fixed-point cleaning or global cleaning, short-press any key to bring the machine to pause.
Mop cloth assembly Main brush cover Main brush cover Side wheel Side wheel Battery Side brush Cliff sensor Caster Description of Indicator Status Cliff sensor Machine status Status of power indicator Status of recharge indicator Charging Breathing in white Off Standby/pause Hibernate Cleaning/remote control Recharging Blinking in white Off Normally on in white (becoming darker) Off Normally on in white Off � Off Normally on in orange
Charging electrode tip Reset button Press and hold for � second to restart Press and hold for � seconds to restore the factory settings Dust bin release button Description of Indicator Status Machine status Wall-following position sensitive detector Status of power indicator Status of recharge indicator Abnormal Blinking in orange Off Wi-Fi reset/not connected/being connected Blinking in orange Blinking in orange Turned off Wi-Fi connected Off Blinking in white � Off Off
�.
Install the Dust Collection Charging Pile Lay the dust collection charging pile on the flat ground over �cm away from the wall, insert the power plug into the socket meeting the requirements, and connect the power supply. Placed against the wall Ensure that there are no obstacles within �.�m in front of the dust collection charging pile and �.�m on both sides.
Use Remove the Limit Bar Put the sweeping and mopping robot on the flat indoor ground, and remove the protection device of limit bar at both ends of the front bumper. Remove Charging of the Sweeping and Mopping Robot Press and hold the button for � seconds to start the sweeping and mopping robot, and then short-press the button to make the robot recharge automatically. The robot enters the ready state once fully charged. Fully charge the sweeping and mopping robot before starting cleaning.
Connect to Lydsto APP Lydsto APP can be downloaded from Apple APP market or Google APP market. Or Scan the following QR code,Download and install Lydsto APP. Reset Wi Fi Press and hold the buttons and for � seconds, then you will hear a voice prompt "Wi Fi has been reset", the power indicator and the recharge indicator will blink in orange, and the sweeping and mopping robot will enter the state of waiting connection. Tips: only �.�GHz frequency band Wi Fi network is supported.
On/Off/Pause Press and hold the button for � seconds to turn on the machine; the power indicator blinks in white after blinking in white slowly for � seconds, and then the sweeping and mopping robot enters the standby state; short-press the button to start the global cleaning; or press and hold the button for � seconds to start the fixed-point cleaning. When the robot i s still, press the button for � seconds to turn off the machine.
Maintenance and Upkeeping Replace the Dust Bag When the dust bag is full, the indicator of the dust collection charging pile is normally on in orange, and a voice prompt or app notice is given. Please replace the dust bag in time. When the dust bag is in normal use, the indicator is normally on in white for a long time.
Clean the Dust Passage If the indicator of the dust collection charging pile still keeps on in orange after the dust bag is replaced, it is recommended to pull out the power plug and reverse the dust collection charging pile to check whether there are foreign matters blocking the dust passage. If the dust passage is blocked, refer to the figure below and remove the transparent cover of the dust passage with a screwdriver to remove foreign matters. Note: violent disassembly is prohibited.
Clean the Infrared Lens/Charging and Dust Collection Sensor Head Wipe them gently with a clean, soft, dry cloth. It is recommended to clean them once a month.
Clean the Flter Screen of the Fan The filter screen of the fan is below the dust bag. If there is dust accumulation, wipe it gently with a clean, soft, dry cloth. It is recommended to clean them once a month.
Clean the Main Brush � Cut off the hair wound on the main brush with the cleaning knife,and then clean the main brush with the cleaning brush at the other end of the cleaning knife. The main brush is consumable and should be cleaned at least once a week. It is recommended to replace the main brush every �-�� months to ensure the cleaning effect. � Reverse the sweeping and mopping robot, press the snap on the main brush cover, and remove the main brush cover and the main brush.
Clean/Replace the Side Brush � Remove the side brush with a screwdriver. � Replace the side brush after cleaning, or install a new side brush. Remove Install Tips: the side brush is consumable. It is recommended to replace it every �-� months to ensure the cleaning effect.
Dust Collection Charging Pile: Clean the Sensors Infrared lens � It is recommended to use a clean, soft, dry cloth to wipe each sensor gently every week to ensure the normal use of the machine.
Clean the Two-in-one Water Tank � Press and hold the release button of the two-in-one water tank and at the same time pull it outwards.
� Open the dust bin by pressing the dust bin snap. Take out the filter screen. Filter screen clip Filter screen � Remove the filter screen clip.
� Remove the debris on the filter screen and screen clip with a cleaning brush. � Turn on the tap to clean the dust bin. � Open the water tank cover and inject an appropriate amount of water. Tips: The filter screen is consumable. It is recommended to replace it every �-� weeks. Please make a purchase through the official channel. Tips: It is suggested to use pure water without any cleaning agent.
Press the mop cloth support snap, and at the same time pull the mop cloth support outwards, to remove the mop cloth or disposable mop cloth for replacement or cleaning. Note: The disposable mop cloth can't be reused, but the mop cloth can be reused after cleaning. Tips: If the mop cloth is too dirty, it will affect the mopping effect. Please clean it in time. Be sure to remove the mop cloth, clean and screw dry before replacing for use.
Troubleshooting When the machine runs abnormally, the power indicator will blink in orange, and the machine will give a voice prompt when some faults occur. Please refer to the table below for a solution.
Voice prompt/fault phenomena Solution Possible causes Cannot be charged �. The dust collection charging pile is not electrified �. The charging electrode tip is dirty �.
In case of abnormal operation of the dust collection charging pile, the indicator of the dust collection charging pile will be normally on in orange. The dust collection charging pile will give a voice prompt for some faults. Please refer to the table below to try to solve problems.
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part �� of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
