Safety Instructions

Installation Using the robot

4. Power and charge

1. Auto: After cleaning, the robot will automatically return to the charging dock to charge.

2. Manual: In Pause mode, press the button to send the robot back to the charging dock.

3. Recharge by remote control.

Note:

1. The battery is fully charged to prolong the battery life. 5 hours charging time for the first time.

2. Please keep charging dock power on, or the robot can not find the charging dock.

Recharge Button Indication in Charging

Charging Status

Low power/Back to charge

Charging

Charging completed

Blue light

Blue light off

Flashing blue

Indicator of Recharge Button

5.Power on/off/Pause

1.Turn on the main power switch “ I ” is turned on, ”o ” is turned off.

2. Press to start cleaning

(Start up the default ”zig-zag ” auto cleaning mode)

4. The robot is not working if leaving dock station The robot will be in standby mode.

If the robot does not work for a long time

, please disconnect the power.

3. Press the button again to stop cleaning (The robot is in standby mode)

6. Water tank

1. Open the water tank,

fill it with water, and close it tightly.

2. Install the mop cloth.

3. Install water tank.

4. Start mopping.

Note:

After finishing mopping, please empty the water tank.

Take off the mop and clean it.

Note:

It is recommended that all ȵRRUVare vacuumed at least three times before the

ȴUVWmopping session to reduce excessive dirt build up on the mop.

Do not put detergent, disinfectants, perfume, or other chemicals in the water tank.

Remove the mopping module after mopping, empty residual water and clean the

mop cloth to prevent mildew or unpleasant odors.

Remove the mopping module if not mopping.

PEN