User's Manual

SET

MEASUREMENT

2.After finishing the measurement, the LCD displays the blinking

icon ‘ ’,and transmits the data.

Note:

(1). The symbol “ ” will disappear after successful data transmission, and you

may check your personal health data stored in your mobile device.

(2). If the data transmission fails, the symbol “ ” will remain. The pending

measurement data will be transmitted to your mobile device when next

measurement is complete.

(3). If you have set the [Positioning Symbol] on, when you start the

measurement, the blood pressure monitor will detect the position first. The

wrist must beat the angle between 30°and 45°. If it’s out of this angle, the

LCD won’t start any measurements and will display blinking symbol “ ”

until you have the correct position. If you get the correct position, it will

display “ ” for about 3 seconds, and then finish the whole measurement.

Tips:

1. There are two users in total. Each user has 60 records.

2. You can press “ ” button to stop measuring during the process

of the measurement at any time.

3. If the measurement result is out of the measurement range (SYS:

60mmHg to 230mmHg; or DIA: 40mmHg to 130mmHg;or Pulse:

40-199 pulse/minute), the LCD will display “out”.

During the measurement or when the measurement is finished,

press “ ”button to turn off the monitor. Otherwise it will power

off in one minute.

CAUTION

Interference may occur in the vicinity of equipment marked with the following symbol . And

TMB-1598-BS may interfering vicinity electrical equipment.

Sensitive people, including pregnant women pre-eclamptic and those who implanted medical

electronic instruments, should avoid using the unit whenever possible.

Keep the monitor at least 20 centimeters away from the human body (especially the head) when the

data transmission is proceeding after measurement.

To enable the data transmission function, this product should be paired to Bluetooth end at 2.4

GHz.

How to mitigate possible interference?

The range between the device and BT end should be reasonably close, from 1 meter to 10 meters.

Please ensure no obstacles between the device and BT end so as to obtain quality connection and

to lower the RF output range.

To avoid interference, other electronic devices (particularly those with wireless transmission /

Transmitter) should be kept at least 1 meter away from the monitor.

MEASUREMENT