User's Manual

In order to get the best effect and protect your monitor,please use the right
battery and special power adaptor which complies with U.S. safety standard.
• .Open the battery cover.
• .Install the batteries by matching
the correct polarity, as shown.
• .Replace the battery cover.
Installing and Replacing the Batteries
CAUTION
Replace the batteries whenever the below happen
The shows
The display is dim
The display does not light up
The Choice of Power Supply
1.Battery powered mode:
6VDC 4×AA alkaline batteries
2.AC adaptor powered mode:
6V 1A
(Please only use the recommended AC
adaptor model).
Please unplug the adaptor to depart from
the using utility power.
Setting Date, Time and Measurement Unit
1.
2.
AC adaptor
It is important to set the clock before using your blood pressure
monitor, so that a time stamp can be assigned to each record that is
stored in the memory. (The setting range of the year :2016—2056;
Time format:24H)
When the monitor is off, press “ ”button,it will display the time.Then press and
hold “ ” button to enter the mode for year setting.
(Notes:
1.During the process of setting, you can press “ ” button to stop setting at
any time.
2. If there is no operation during the process of setting, it will turn off within 1
minute.)
Press “ ” button to change
the [YEAR]. Each press will
increase the numeral by one in a
cycling manner.
CAUTION
Do not use new and used batteries together.
Do not use different types of batteries together.
Do not dispose the batteries in fire. Batteries may explode or leak.
Remove batteries if the device is not likely to be used for some time.
Worn batteries are harmful to the environment. Do not dispose with daily garbage.
Remove the old batteries from the device following your local recycling guidelines.
The typical service life of the new and
unused batteries is 300 measurements
for the operation time is 60s.
9
8
BEFORE YOU START BEFORE YOU START