User's Manual

The Choice of Power Supply
In order to get the best effect and protect your monitor,please use the right
battery and special power adaptor. The power adapter is a part of the device.
After using, please pull out the adaptor plug insulates from the main supply.
Do not position the device in a position where it is difficult to disconnect from
the supply mains.
1.Slide off the battery cover.
2.Install the batteries by
matching the correct polarity,
as shown.
3.Replace the cover.
1.Battery powered mode:
6VDC 4*AA alkaline batteries
2.AC adaptor powered mode:
6V 1A
(Can be supplied by AC adaptor model
UE08WCP-060100SPA !)
Right picture is the hole in for
power adaptor.
Installing and Replacing the Batteries
CAUTION
Remove batteries if the device is not likely to be used for some time.
The old batteries are harmful to the environment, do not dispose with other
daily trash.
Remove the old batteries from the device and follow your local recycling
guidelines.
CAUTION
Replace the batteries whenever the below happen
The shows
The display dims
The display does not light up
When the blood pressure monitor is off, press On/Standby button for
2 full seconds to enter bluetooth pairing mode. The symbol
flashes, indicating the pairing is proceeding.
Turn on Bluetooth and APP. Make sure both are ON when pairing is
proceeding.
Then please select the user ID you want to connect with your
smartphone on the app to continute the pair-up.
If succeed, symbol will be shown. Then blood pressure monitor
will turn off.
If fail, symbol will flash all the time until the blood pressure
turns off.
Pairing
Bluetooth Module No.: LS51802
RF Frequency Range: 2402 MHz to 2480 MHz
Output Power Range: -3.21 dbm
Supply Voltage: 2V-3.6 V
Transmitting Distance: 10 meters
BEFORE YOU START MEASUREMENT
98