User's Manual

Rest for 5 minutes before
measuring.
Wait at least 3 minutes between
measurements. This allows your
blood circulation to recover.
For a meaningful comparison,
try to measure under similar
conditions. For example, take daily
measurements at approximately
the same time, on the same upper
arm, or as directed by a physician.
Tie the Cuff
1.Tie the cuff on your upper arm,
then position the tube off-center
toward the inner side of arm in
line with the little finger.
2.The cuff should be snug but not
too tight. You should be able to
insert one finger between the
cuff and your arm.
3.Sit comfortably with your arm
resting on a flat surface.
2~3cm
4.Correct position:
- Bare your arm or wear tights only
when starting measurement.
- Sit comfortably with legs
uncrossed, feet flat on the floor,
back and arm supported.
The center of the cuff should be at
the same level as the right atrium
of the heart.
When the blood pressure monitor is off, press On/Standby button for
2 full seconds to enter bluetooth pairing mode. The symbol
flashes, indicating the pairing is proceeding.
Turn on Bluetooth and APP. Make sure both are ON when pairing is
proceeding.
Then please select the user ID you want to connect with your
smartphone on the app to continute the pair-up.
If succeed, symbol will be shown. Then blood pressure monitor
will turn off.
If fail, symbol will flash all the time until the blood pressure
turns off.
Pairing
Bluetooth Module No.: AW2540MV1
RF Frequency Range: 2402 MHz to 2480 MHz
Output Power Range: -1 dBm
Supply Voltage: 2V-3.6 V
Transmitting Distance: 10 meters
MEASUREMENT MEASUREMENT
98