User's Manual

Component list of
pressure measuring system
1 Cuff
2 Air pipe
3 PCBA
4 Pump
5 Valve
Monitor Components
BATTERY COMPARTMENT
ON/STANDBY BUTTON
LCD DISPLAY
AIR HOSE
AIR CONNECTOR PLUG
CUFF
List
1. Blood Pressure Monitor
(TMB-1591)
4. User manual
3. 4*AA alkaline Batteries
2. Cuff (22cm~42cm)
(Type BF applied part)
5. AC adaptor (UE08WCP-060100SPA)
DC POWER SOCKET
The Choice of Power Supply
In order to get the best effect and protect your monitor,please use the right
battery and special power adaptor. The power adapter is a part of the device.
After using, please pull out the adaptor plug insulates from the main supply.
Do not position the device in a position where it is difficult to disconnect from
the supply mains.
１.Slide off the battery cover.
２.Install the batteries by
matching the correct polarity,
as shown.
３.Replace the cover.
1.Battery powered mode:
6VDC 4*AA alkaline batteries
(Notes: A groups of new batteries can be
used about 750 times.
2.AC adaptor powered mode:
6V 1A
(Can be supplied by AC adaptor model
UE08WCP-060100SPA !)
Right picture is the hole in for
power adaptor.
Installing and Replacing the Batteries
CAUTION
Remove batteries if the device is not likely to be used for some time.
The old batteries are harmful to the environment, do not dispose with other
daily trash.
Remove the old batteries from the device and follow your local recycling
guidelines.
CAUTION
Replace the batteries whenever the below happen
The shows
The display dims
The display does not light up
INTRODUCTION BEFORE YOU START
76