version:1.0 User Manual Blood Pressure Monitor TMB-1591 Arm Type Thank you very much for selecting TRANSTEK Blood Pressure Monitor TMB-1591. Guangdong Transtek Medical Electronics Co., Ltd. Zone A, No.105 ,Dongli Road, Torch Development District, Zhongshan,528437,Guangdong,China To use the monitor correctly and safely, please read the manual thoroughly. Please keep this manual well in order to reference in future.
CATALOGUE CATALOGUE Table of Contents INTRODUCTION........................................................................................2 General Description Safety Information Indications for Use LCD Display Signal Monitor Components BEFORE YOU START................................................................................7 The Choice of Power Supply Installing and Replacing the Batteries MEASUREMENT.......................................................................................
INTRODUCTION General Description Thank you for selecting TRANSTEK arm type blood pressure monitor (TMB-1591). The monitor features blood pressure measurement, pulse rate measurement and the result storage. The design provides you with two years of reliable service. Readings taken by the TMB-1591 are equivalent to those obtained by a trained observer using the cuff and stethoscope auscultation method.
INTRODUCTION CAUTION This device is intended only for adult use in homes. This device is intended for non-invasive measuring and monitoring of arterial blood pressure. It is not intended for use on extremities other than arm or for functions other than obtaining a blood pressure measurement. If you experience discomfort during a measurement, such as pain in the arm or other complaints, press the START/STOP button to release the air immediately from the cuff. Loosen the cuff and remove it from your arm.
INTRODUCTION BEFORE YOU START The Choice of Power Supply Monitor Components 1.Battery powered mode: CUFF 6VDC 4*AA alkaline batteries (Notes: A groups of new batteries can be used about 750 times. AIR HOSE 2.AC adaptor powered mode: 6V 1A (Can be supplied by AC adaptor model UE08WCP-060100SPA !) AIR CONNECTOR PLUG Right picture is the hole in for power adaptor.
MEASUREMENT MEASUREMENT Pairing Tie the Cuff Turn on Bluetooth and APP. Make sure both are ON when pairing is proceeding. When the blood pressure monitor is off, press On/Standby button for 2 full seconds to enter bluetooth pairing mode. The symbol flashes, indicating the pairing is proceeding. 1.Tie the cuff on your upper arm, then position the tube off-center toward the inner side of arm in line with the little finger. 2.The cuff should be snug but not too tight.
MEASUREMENT MEASUREMENT Start Measurement When the blood pressure monitor is off, press On/Standby button to turn it on, it will finish the whole measurement. LCD display Inflating and Measuring The blood pressure monitor will proceed to data transmission after measurement. The bluetooth symbol flashes on the LCD indicates data is transmitting. Adjust to zero. Display and save the result. After successful transfer, the device powers off the Bluetooth radio and the icon (and rectangle) are removed.
MEASUREMENT INFORMATION FOR USER Tips for Measurement During the measurement, if you press the On/Standby button to stop the measurement, the numerics are cleared. It will display as below: Measurements may be inaccurate if taken in the following circumstances. wait at least 1 hour after dinner or drinking If you press and release the On/Standby button, another reading is initiated. If you press and hold the On/Standby button for 2 seconds, the device powers down.
INFORMATION FOR USER ABOUT BLOOD PRESSURE What are systolic pressure and diastolic pressure? Maintenance In order to get the best performance, please follow the instructions below. When ventricles contract and pump blood out of the heart, the blood pressure reaches its maximum value in the cycle, which is called systolic pressure. When the ventricles relax, the blood pressure reaches its minimum value in the cycle, which is called diastolic pressure.
ABOUT BLOOD PRESSURE TROUBLESHOOTING This section includes a list of error messages and frequently asked questions for problems you may encounter with your blood pressure monitor. If the products not operating as you think it should, check here before arranging for servicing. Why does my blood pressure fluctuate throughout the day? 1. Individual blood pressure varies multiple times everyday.
SPECIFICATIONS Power supply Display mode Measurement mode Measurement range Accuracy Normal working condition AUTHORIZED COMPONENT Battery powered mode: 6VDC 4*AA alkaline batteries AC adaptor powered mode: 6V 1A (Can be supplied by AC adaptor model UE08WCP-060100SPA !) Authorized Component １.please use the TRANSTEK authorized adapter. Digital LCD V.A.
COMPLIED STANDARDS LIST Complied Standards List Risk management Labeling ISO/EN 15223-1:2012 Medical devices. Symbols to be used with medical device labels, labelling and information to be supplied.
IC STATEMENT IC Statement IC ID：12725A-TMB1591B This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
