User's Manual

9
8
BEFORE YOU START
Setting Date, Time and Measurement Unit
It is important to set the clock before using your blood pressure
monitor, so that a time stamp can be assigned to each record that
is stored in the memory. (The setting range of the year :2018—2058
time format:24H)
1.When the monitor is off,
hold pressing “SET” button
for 3 seconds to enter the
mode for year setting.
2.Press the “MEM” button to
change the [YEAR]. Each
press will increase the
numeral by one in a
cycling manner.
3.When you get the right
year, press “SET” button
to confirm then it will turn to
next step.
BEFORE YOU START
In order to get the best effect and protect your monitor,please use the right
battery and special power adaptor which complies with local safety standard.
• .Open the battery cover.
• .Install the batteries by matching
the correct polarity, as shown.
• .Close the cover.
Installing and Replacing the Batteries
CAUTION
Replace the batteries whenever the below happen
The shows
The display is dim.
The display does not light up
AC adaptor
The Choice of Power Supply
1.Battery powered mode:
6VDC 4×AAA batteries
2.AC adaptor powered mode:
6V 1A
(Please only use the recommended AC
adaptor model).
Please unplug the adaptor to depart from
the using utility power.
CAUTION
Do not use new and used batteries together.
Do not use different types of batteries together.
Do not dispose the batteries in fire. Batteries may explode or leak.
Remove batteries if the device is not likely to be used for some time.
Worn batteries are harmful to the environment. Do not dispose with daily garbage.
Remove the old batteries from the device following your local recycling guidelines.
The typical service life of the
new and unused batteries is 300
measurements for the operation
time is 60s.
BEFORE YOU START