User's Manual

If you did not get the correct measurement, you can delete all

results by following steps below. (Take user 1 for example)

Delete the Records

1.Hold pressing “MEM” button

for 3 seconds when the

monitor is in the memory

recall mode ,the “User ID

+ dEL ALL” will flash on the

display.

2.Press “SET” button to

confirm deleting and

the monitor will display

“dEL dOnE”+User ID and

then turn off.

3. If there is no record.

the following display will

be shown.

Note: To exit the delete mode

without deleting any records,

press START/STOP button

before pressing "SET" to confirm

any delete commands.

DATA MANAGEMENT

SPECIAL FUNCTION

Hold pressing the Lock button

until the LCD displays “OFF”,

this indicates the touch keys

(such as MEM, START/STOP,

SET) have been locked.

Hold pressing the Lock button

until the LCD displays “ON” to

unlock the keys. You can press

any buttons to use the blood

pressure monitor.

About the Lock Button

The unnecessary keys’ touch will make the blood pressure

monitor turn on and waste electricity. To avoid this, you can

press the Lock button to lock the keys if necessary.