User's Manual

ManualsBrandsGuangdong Transtek Medical Electronics ManualsBlood Pressure MonitorsBlood Pressure Monitor

MEM

SET

START

STOP

In order to get the best effect and protect your monitor,please use the right

battery and special power adaptor which complies with U.S. safety standard.

• .Open the battery cover.

• .Install the batteries by matching

the correct polarity, as shown.

• .Replace the cover.

Installing and Replacing the Batteries

CAUTION

Remove batteries if the device is not likely to be used for some time.

The old batteries are harmful to the environment, do not dispose with other daily trash.

Remove the old batteries from the device and follow your local recycling guidelines.

CAUTION

Replace the batteries whenever the below happen

The shows

The display dims

The display does not light up

Do not dispose of batteries in fire. Batteries may explode or leak.

AC adaptor

The Choice of Power Supply

1.Battery powered mode:

6VDC 4×AAA alkaline batteries

2.AC adaptor powered mode:

6V 1A

(Please only use the recommended AC

adaptor model).

Please unplug the adaptor to depart from

the using utility power.

Measurement Principle

It is important to set the clock before using your blood pressure

monitor, so that a time stamp can be assigned to each record that

is stored in the memory. (The setting range of the year :2014—2054

time format:12H/24H)

1.When the monitor is off,

hold pressing “SET” button

for 3 seconds to enter the

mode for year setting.

2.Press the “MEM” button to

change the [YEAR]. Each

press will increase the

numeral by one in a

cycling manner.

This product uses the Oscillometric Measuring method to detect blood pressure. Before

every measurement, the unit establishes a “zero pressure” equivalent to the air pressure.

Then it starts inflating the arm cuff, meanwhile, the unit detects pressure oscillations

generated by beat-to-beat pulsatile, which is used to determine the systolic and diastolic

pressure, and also pulse rate.

The device also compares the longest and the shortest time intervals of detected pulse

waves to mean time interval then calculates standard deviation. The device will display a

warning signal with the reading to indicate the detection of irregular heartbeat when the

difference of the time intervals is over 25%.

Setting Date, Time, Measurement Unit

and Clock Mode

BEFORE YOU START