User's Manual

1.
2.Press “S” to confirm
deleting , the LCD displays
“ dEL dOnE” and the monitor
will turn off.
If you did not get the correct measurement, you can delete all
results by following steps below . (Take User 1 for example.)
Delete the Records
3.If there is no record. the
right display will show.
In the memory mode, hold
pressing “M” button for
3 seconds, the flash display
“User ID+ dEL All” will show.
The most recent record (1) is shown first. Each new measurement
is assigned to the first (1) record. All other records are pushed back
one digit (e.g., 2 becomes 3, and so on), and the last record (60) is
dropped from the list.
CAUTION
3. If you want to check the other user’s
measurement records, please press
“START/STOP” button to turn off the blood
pressure monitor. Then press and hold “M”
button to enter the selecting user mode, press
“M” again to change the user, when the desired
user ID blinks, press “S” button to confirm. Then
press “M” button to check the records of the
selected user.
Recall the Records
1.
2.
The date and time will
display alternately.
When the monitor is off, press “M” button to
show the average value of the latest three
measurement records. (Take User 1 for
example.)
Press “M” button or “S”
button to get the
record you want.
The corresponding
time is 9:10.
The corresponding
date is May 11 .
th
Note: To exit out of delete
mode without deleting any
records, press START/STOP
button before pressing “S” to
confirm any delete commands.
17
16
DATA MANAGEMENT DATA MANAGEMENT