User's Manual



Rest for 5 minutes before
measuring.
Wait at least 3 minutes between
measurements. This allows your blood circulation to recover.
For a meaningful comparison,
try to measure under similar conditions. For example, take daily measurements at approximately the same time, position of upper arm, or as directed by a physician.
Tie the cuff
1.Tie the cuff on your upper arm,
then position the tube off-center toward the inner side of arm in line with the little finger.
2.The cuff should be snug but not
too tight. You should be able to insert one finger between the cuff and your arm.
3.Sit comfortably with your tested
arm resting on a flat surface.
2~3cm
START
STOP
.Patients with Hypertension:
The middle of the cuff should be at the level of the right atrium of the heart; Before starting measurement, please sit comfortably with legs uncrossed, feet flat on the floor, back and arm supported.
4
Pair-up the Blood Pressure Monitor with Your Device
1.Turn on Bluetooth and the app. Make sure both are ON when pair-up is
proceeding.
2.When the monitor is OFF, press and hold the START/STOP button to start
pair-up. The symbol and will be shown on the LCD alternatively, indicating pair-up is proceeding.
If SUCCEED, symbol will be shown on the LCD.
If FAIL, only bluetooth symbol
will be shown on the LCD.
4.The monitor will shut off after Pair-up process is
complete.
3.Then please select the user ID you want to connect with your smartphone on the app to continute the pair-up.
MEASUREMENTBEFORE YOU START
Bluetooth Module No.: AW8001 RF Frequency Range: 2402 MHz to 2480 MHz Output Power Range: 0 dBm Supply Voltage: 1.8-3.6 V Transmitting Distance: 10 meters