Guangdong Transtek Medical Electronics Co., Ltd. Zone A, No.105 ,Dongli Road, Torch Development District, Zhongshan,528437,Guangdong,China Arm Type TMB-1490-BT Please do read the user manual carefully and thoroughtly so as to ensure the safe usage of this product, and keep the manual well for further reference in case you have problems. Thank you very much for selecting TRANSTEK Blood Pressure Monitor TMB-1490-BT. Blood Pressure Monitor User Manual version:1.
TROUBLESHOOTING.......................................................................................................21 SPECIFICATIONS..............................................................................................................22 AUTHORIZED COMPONENT ...........................................................................................23 CONTACT INFORMATION.................................................................................................23 COMPLIED STANDARDS LIST....
F1 For indoor use only Symbol for “Class II Equipment” Symbol for “Including RF transmitter” 7 $ 9 ĭ &&& The Bluetooth Combination Mark Symbol for “ENVIRONMENT PROTECTION - Electrical waste products should not be disposed of with household waste. Please recycle where facilities exist.
mmHg kPa Pul/min SYMBOL CUFF air is exhausting of deflating The displayed measurement values is from the memory.
AC adaptor shows Remove the old batteries from the device and follow your local recycling guidelines. Do not dispose of batteries in fire. Batteries may explode or leak. The old batteries are harmful to the environment, do not dispose with other daily trash. Remove batteries if the device is not likely to be used for some time. CAUTION The display does not light up The display dims The Replace the batteries whenever the below happen Open the battery cover.
2.Press the “MEM” to change the [YEAR]. Each press will increase the numeral by one in a cycling manner. 1.When the monitor is off, hold pressing “SET” for 3 seconds to enter the mode for year setting. TIME/DATE MEMORY TIME/DATE MEMORY Pul/min Pul/min STOP START S M STOP START S M It is important to set the clock before using your blood pressure monitor, so that a time stamp can be assigned to each record that is stored in the memory.
Pul/min STOP START S M Pul/min STOP STOP TIME/DATE Pul/min START START MEMORY S Pul/min M STOP S TIME/DATE Pul/min START S M M MEMORY TIME/DATE MEMORY 8.After the unit is set,the LCD will display “dOnE”first,then display all the settings you have done and then it will turn off. TIME/DATE MEMORY 7.Repeat steps 2 and 3 to set the [UNIT]. TIME/DATE MEMORY 6.Repeat steps 2 and 3 to set the [HOUR] and [MINUTE]. BEFORE YOU START STOP START S M Bluetooth Module No.
Rest for 5 minutes before measuring. Wait at least 3 minutes between measurements. This allows your blood circulation to recover. For a meaningful comparison, try to measure under similar conditions. For example, take daily measurements at approximately the same time, position of upper arm, or as directed by a physician. 4.
TIME/DATE MEMORY TIME/DATE MEMORY TIME/DATE MEMORY STOP START Pul/min Pul/min Pul/min Tips: Maximum 60 records are both for User A and User B. 4 3UHVV WKH ³67$576723´ WR SRZHU off, otherwise it will turn off within 1 minute. If the data transmission fails, the LCD will display “ Err ” instead. 3.If the data is successfully transmitted, the LCD will then display “dOnE”. 2.This device will proceed to data transmission after measurement.
4. If there is no record. Press “MEM” button, the right display will show. 3.If you don’t want to delete the records, press “START/STOP” to escape. 2.Press “SET” to confirm deleting and the monitor will turn off. 1.Hold pressing “MEM” for 3 seconds when the monitor is in the memory recall mode ,the flash display “dEL ALL” will show.
CAUTION Please use ACCESSORIES and detachable partes specified/ authorised by MANUFACTURE. Otherwise, it may cause damage to the unit or danger to the user/patients. The device doesn’t need to be calibrated within the two years of reliable service. Please dispose of ACCESSORIES, detachable parts, and the ME EQUIPMENT according to the local guidelines. If you have any problems with this device, such as setting up, maintaining or using, please contact the SERVICE PERSONNEL of Transtek.
It is ok for both arms, but there will be some different results for different people. We suggest you measure the same arm every time. Is the result the same if measuring on the right arm? The blood pressure is different even throughout the day due to weather, emotion, exercise etc, Also, there is the “white coat” effect, which means blood pressure usually increases in clinical settings. Why do I get a different blood pressure at home compared to the hospital? 3.
IP21 V01 Protection against ingress of water Software Version WARNING: No modification of this equipment is allowed. Type BF applied part Continuous operation 4×AAA batteries,user manual Approx.140mm×130mm×49.7mm Approx.
IEC 80601-2-30:2009 Medical electrical equipment- Part 2-30: Particular requirements for the basic safety and essential performance of automated non-invasive sphygmomanometers ANSI/AAMI SP10:2002/A2: 2008 Manual, electronic, or automated sphygmomanometers IEC/EN 62304:2006+AC: 2008 Medical device software - Software life cycle processes Software life-cycle processes IEC/EN 60601-1-2:2007 Medical electrical equipment Part 1-2: General requirements for basic safety and essential performance - Collatera
(Note: As indicated in Table 6 of IEC 60601-1-2:2007 for ME EQUIPMENT, a typical cell phone with a maximum output power of 2 W yields d=3, 3m at an IMMUNITY LEVEL of 3V/m) 2. Wireless communications equipment such as wireless home network devices, mobile phones, cordless telephones and their base stations, walkie-talkies can affect this equipment and should be kept at least a distance d=3, 3m away from the equipment. 1.