Use Instructions
14
2.
will release. The pulse symbol ( ) will display, along
with systolic and diastolic pressure.
3.
An icon will appear in the LCD Display to indicate
whether you were suciently rested during the
measurement ( = Rested, = Not rested). See
the „Resting Indicator“ subsection below for details.
4.
Er_ (where the blank space
is a number 1-8) will appear
if the measurement was not
performed properly. Refer to the
„Troubleshooting Guide“ section
for details about specific error
message numbers and then
repeat the measurement.
5. To select a desired user memory, press the M1 or M2
Button. Each of the two user memories can store 120
sets of measurements. If you do not select a user
memory, the measurement will be stored in the most
recently-used user memory.
6.
If Bluetooth
®
data transfer is active, the unit will transmit
measurement data to the "beurer HealthManager
Pro" mobile app installed on your paired mobile
device. The Bluetooth
®
icon will flash while the unit
establishes communication with your mobile device
and will display when a link is successful. After data
unsuccessful, the error message " " will display.
Also, if the unit cannot establish a Bluetooth
®
NOTE: Remember that you must add the SERIES 800W
blood pressure monitor to the "beurer HealthManager
Pro" app to enable data transfer.
7.
Press the START/STOP
pressure monitor if needed. The measurement is stored
in the selected user memory. The device will also shut
8.
Wait at least five minutes before taking another
measurement.