User's Manual

Tie the Cuff
1.
2.
3.
4.
5.
Remove all accessories (watch, bracelet,etc) from your arm. If your physician has
diagnosed you with poor circulation in your arm, use the other one.
Roll or push up your sleeve to expose the skin.
Apply the cuff to your arm with your palm facing up.
Position the edge of the cuff about 2cm~3cm from elbow.
Fasten the cuff around your arm, leaving no extra room between the cuff and your
skin. If the cuff is too loose, the measurement will not be accurate.
Sit comfortably with your tested arm resting on a flat surface. Place your elbow on a
table so that the cuff is at the same level as your heart. Turn your palm upwards.
Sit upright in a chair, and take 5-6 deep breaths.
Rest for 5 minutes before first measuring.
Wait at least 3 minutes between measurements. This allows your blood circulation to
recover.
The patient must relax as much as possible and do not move and talk during the
measurement procedure.
For a meaningful comparison, try to measure under similar conditions. For example,
take daily measurements at approximately the same time, on the same arm, or as
directed by a physician.
6.
7.
Take the measurement in a silent room.
The cuff should maintain at the same level as the right atrium of the heart.
Please sit comfortably. Do not cross your legs and keep your feet flat on the ground.
Keep your back against the backrest of the chair.
Helpful tips for Patients, especially for Patients with Hypertension:
Pair up the Blood Pressure Monitor
with Your Device
(2)Press “My devices”,the app will display My Devices tap.
Bluetooth Module No. : LS51802
Frequency Range
Output Power Range
Supply Voltage2.402 - 2.480 GHz
-2.66 dBm
1.8-3.6 V
Transmitting Distance
10 meters
(5)After selecting the device,select the “account” and return;then enter
device to “Set device” .When the app display“Receive data
automatically”，please choose “Yes”.
(1) Turn on Bluetooth and the app. Enter to the APP, then
press “My Setting” ,the app will display My Setting tap.
(4) Press in the APP to reseach,then select “808A0”
to connect the monitor.
(3)When the moniter is off,press press“User 1” to measure,
the will show and will blink after measuring,then the datas
are transmitting.
(6)When the monitor is connected,the datas will transmit to “MedM”,
if transmit successfully,the symbel and will disappear,then the
monitor turn off;or not,it will turn off within one minute.
List of compatible devices:
For iOS devices:
The operating system must be iOS 8 or more, such as iPhone
4S, iPhone 5/5C/5S, iPhone 6/6 Plus and so on.
For Android devices:
The operating system must be 4.3 or more.
14 15
BEFORE YOU START
BEFORE YOU START