User's Manual

FEATURES:
86.1mm×24mm digital LCD display
Measure-during-inflating Technology
Up to 60 pieces of record stored per each user
Measurement Principle
General Description
Indications for Use
* Thank you for selecting TRANSTEK blood pressure monitor (LS808-BS).
The monitor features blood pressure measurement, pulse rate measurement
and the result storage. The design provides you with two years of lifetime.
* This manual contains important safety information and caution, and provides step
by step instructions for using the product.
* Please do read this user manual carefully and thoroughly before use.
The Transtek Blood Pressure Monitor is digital monitors intended for use in
measuring blood pressure and heartbeat rate with arm circumference ranging
from 22 cm to 32 cm ( about 8¾˝-12½˝ ) or 22cm to 42cm(about 8¾˝-16½˝).
It is intended for adult indoor use only.
Contraindications
1.The device should not be used by any person who may be suspected of,or
is pregnant .
2.The device is not suitable for use on patients with implanted,electrical
devices,such as cardiac pacemakers, defibrillators.
This product uses the Oscillometric Measuring Method to detect blood
pressure. Before every measurement, the unit establishes a “zero point”
equivalent to the atmospheric pressure. Then it starts inflating the cuff.
Meanwhile, the unit detects pressure oscillation generated by beat-to-beat
pulsatile, which is used to determine the systolic pressure and diastolic
pressure as well as pulse rate.
Safety Information
The signs below might be in the user manual, labeling or other component.
They are the requirement of standard and using.
The Bluetooth Combination Mark
Refer to instruction manual/booklet
To signify that the instruction manual/booklet must be read.
Symbol for “Manufacturer”
Symbol for “Serial Number”
Symbol for “Type BF applied part”
Symbol for “Direct Current”
The symbol indicates that the product should not be discarded
as unsorted waste but must be sent to separate collection
facilities for recovery and recycling.
Symbol for “Date and Country of manufacture”
For indoor use only
Symbol for “Class II Equipment”
SN
Symbol for “Recycle”
Caution
Indicates that caution is necessary when operating the device
or control close to where the symbol is placed, or that the
current situation needs operator awareness or operator action
in order to avoid undesirable consequences.
INTRODUCTION INTRODUCTION
2 3