User's Manual

1) If DHCP function on router was open, press
reset button for a moment on bridge to make it
reset to factory defaults
2) If DHCP function on router wasn’t open, pls
refer to IP setting up method on bridge (page 5)
Trouble shooting
Symptom
Power connecting error
Data bridge connect to
the router is abnormal
LAN lights up,
WAN is shining
Fault cause Solution
LAN and WAN light turns
green, data was
sucessfully sent from
device, but not shown in
health center
PC can enter the internet
But bridge can’t enter
the internet
Not choose user for
the device
Please check the power connecting situation of
the data bridge
Please add user in device management
interface
Please go to get the data from device
management interface
1) Please check the power connecting situation
of the router
2) Please check the connecting situation
between bridge and router
Turn on power, LAN and
WAN light is shining
Turn on power, LAN
and WAN light is dark
Data can’t automatically
distinguish the user
Advanced setting
(Attention: only for user whose DHCP function on router wasn’t open)
1 Press reset button, and hold it more than
5 seconds LAN and WAN light shining at
the same time, pls loose the button.
2 Connect bridge to PC by
internet cable directly