LS401-E
Before using Product structure 1 Install the bridge. Please refer to the bridge instruction manual. (If already install the bridge, skip the steps.) 2 Register the account and add the members. (If already have the account please skip the steps.) 1) Please enter into www.lifesense.com, make the free account.
2) Register the family account. 3) RAdd a family member.
) Select program. 3 Add the device. 1) Click the device and add the device.
2) Input the serial No. 3) Add the user.
4) Activate the device. 5) wait for activation.
4 Battery charging. 5) Successfully add. Successfully add! The page will be automatically closed in 3 second 1) Put the pedometer into the charging plate. 2) Charging with the usb cable linked to the pc. It finishes in around 1.5 hours, and shows all the indicator lights.
Usage 5 Product’s activation. 1) Device should be less than 1 meter away from the bridge. 2) Long press the button for 5 sec. 3) Successfully activated after it shows you 6 green indicator lights. 1 Measurement and data sending. 1) Log in health care center and set a week target.
4 Go to www.lifesense.com to check how many step you finished. 2 Measure your step wherever you want. 3 Automatically transmit the data to the server when the pedometer is close enough to the bridge. Attention: if you change an user, please long press activation button.
5 Target and battery margin check. Cautions 1) Daily target check Press the button, how many lights you see means how fulfill how many day’s task. In order to avoid others being hurt by the product and extend its lifetime, please obey the following cautions. 2) Weekly target check Press the button after you see the green lights, then you will see orange lights, how many of them you see means how many week task you finish. 3) Power Inquires Press the button when it shows the orange indication light.
About recharging About usage After recharging 2-3 times, the performance can be perfect Please take the pedometer as mentioned Battery duration: 13 days Don’t use the pedometer where it is in strong radiation which would influence the accuracy During charging, it’s normal if the product is a little fever Data can be saved for 30 days before transmitted Charging within 0-40 celsius degree Please don’t disassemble the product if you are not professional All green lights shows if it finishes charging
Clean 1 Use tissue to clean the dirt on the pedometer. 2 Dry the pedometer after clean it with soaped wiping.
Cautions Phenomenon No indicator light Fail activation Reason Methods Low battery Recharging interference Keep closer to the bridge No account Log on www.lifesense.com for setting Activate too many products at the same time Do it one by one Weak signal to the server Check network status Out of transmitting range Fail data uploading Fail display on weekly target and led Product can not be recharged Move the products towards to the bridge. Data can be transmitted in 30m without barrier.
Product Specification Items Product Name Voltage Recharging Display Steps Calories Battery grade Battery releasing Content Battery life 13 days once recharging Pedometer LS401-E Data capacity Data of 30 days 45mAh Lipolymer battery Transmitting range 30 meters (in open place) DC 5.0V, standard usb plug Dimension 60x44.7x11.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
