User's Manual

Please process the user setting before your first measurement.

(Refer to Set Up Your Profile for more details)

Start Measuring

First Measurement

When your scale is successfully paired with your smartphone and the Bluetooth is ON,

LS208-B8 will process data transmission instead.

(Please refer to Data Transmission for more details.)

STEP 3: The measurement results will be displayed followed by Weight, Body Fat,

Total Body Water, Muscle Mass, Bone Mass, Kcal and BMI. The data will be

displayed three times and then turn off.

* If it fails to complete the analysis, the LED will only display the weight data.

(To find out the solutions, please refer to Troubleshooting for more details.)

STEP 1: Step on the platform barefooted

when the LED display “0.0”.

Weight Only Operation

Your TRANSTEK Body Fat Analyzer will operate as a conventional

weight - reading scale. No special programming steps are required.

Once the scale is initialized, as previously described, you may simply step on

the scale to measure your current weight. For only weight reading.

1. Position the scale on a flat, hard surface. Carpeted or uneven floors may

affect accuracy.

2. Step onto the scale platform and remain still while the scale computes your weight.

3. The scale will display your weight value.

4. The scale will automatically turn off after a few seconds.

1. Press the platform centre and remove your foot.

2. “0.0” will be displayed.

3. The scale will switch off and is now ready for use.

This initialisation process must be repeated if the scale is moved.

At all other times step straight on the scale.

Initialising Your Scale

Initial Start-Up

STEP 2: Stand still and the weight data will be locked with blinking twice when the

weight is stable. Keep full contact with the scale until the LED stops

displaying moving “o”.

Note: The weight value won’t be saved in the scale, and won’t be transmitted to the APP.