User's Manual
11
10
Please process the user setting before your first measurement.
(Refer to Set Up Your Profile for more details)
Start Measuring
First Measurement
When your scale is successfully paired with your smartphone and the Bluetooth is ON,
LS208-B7 will process data transmission instead.
(Please refer to Data Transmission for more details.)
STEP 3: Then the measuring results will be displayed sequentially three times:
Body Fat, Total Body Water, Muscle Mass, Bone Mass,Calorie, BMI, and
Weight.
* If it fails to complete the analysis, the LED will only display the weight data.
(To find out the solutions, please refer to Troubleshooting for more details.)
STEP 1: Step on the platform barefooted.
Weight Only Operation
Your TRANSTEK Body Fat Analyzer will operate as a conventional
weight - reading scale. No special programming steps are required.
Once the scale is initialized, as previously described, you may simply step on
the scale to measure your current weight. For only weight reading.
1. Position the scale on a flat, hard surface. Carpeted or uneven floors may
affect accuracy.
2. Step onto the scale platform and remain still while the scale computes your weight.
3. The scale will display your weight value.
4. The scale will automatically turn off after a few seconds.
1. Press the platform centre and remove your foot.
2. “0.0” will be displayed.
3. The scale will switch off and is now ready for use.
This initialisation process must be repeated if the scale is moved.
At all other times step straight on the scale.
Initialising Your Scale
Initial Start-Up
STEP 2: Stand still and keep full contact with the electrodes until the LED stops
displaying moving “o”.
Note: The weight value won’t be saved in the scale, and won’t be transmitted to the APP.