Parts List
Ｅ
Ｅ
Ｅ
11
1. Hovering the aircraft around the center point.
2. Press “ + ”on the transmitter at the same time.
3. Moving and setting the aircraft surround radius range (within 2 meters-100
meters)by the Direction Joystick.
4. Press “ + ” on the transmitter at the same time again, then the
aircraft starts to fly arround according to the radius range you set in STEP 2
(Note: If the surround radius range less than 2 meters, the aircraft will fly
to 2 meters automatically) . Move the Direction Joystick to cancel the
Point of Interest mode.
NOTE: Press “ + ” on the transmitter at the same time, Point of
Interest Function” can be activated if the aircraft and transmitter
sucessfully paired and the aircraft flies up .
WAY POINT FLIGHT
— Make sure the mobile internet connected, enter in the APP, catch the
map data of the area when you intend to fly in your mobile device, then
connect your mobile device with your aircraft, you can view the map from
in the APP.
— Successfully connect the aircraft WIFI with your smart phone, click on
the App, then you can find a RED CIRCLE(LIMITTED FLIGHT RANGE)/TAKE-
OFF POSITION/AIRCRAFT CURRENT POSITION on the map, mark the points
(16 points at most) you plan to fly within the RED CIRCLE range on the map.
If you would like to reset the points or flight route, click or .
Click ,confirm to start Way Point Flight. Pushing the Right Joystick
to cancel the Way Point Flight Function.
Delete single
Send
Delete all
POINT OF INTEREST
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.