User's Manual

 The radio will be slightly warm during charging.
GENERAL OPERATIONS
1. TRANSMITTING RANGE
 The talk range depends on the environmental and terrain. It
will be reach (up to about 10km) in wide open spaces, without
obstructions such as hills or buildings. Don’t try to use two
PMR units which are less than 1.5m (5feet) apart. If you do,
you may have experience interference.
2. POWER ON/OFF
 To power On the radio, press Power On/Off Key
for 2
seconds until a beep is heard and the LCD display turn on.
 To power Off the radio, press Power On/Off key for 2
seconds until LCD display turns off.
3. MAKING COMMUNICATIONS
The radio has 8 main frequencies and 38 CTCSS codes or 83 DCS
codes effectively giving you 968 channels. You can communicate
with any other user who is using the same combinations, providing
they are within range.
4. SPEAK TO OTHER RADIO
 Press & hold the PTT key, LCD TX icon indicating the radio is
transmitting.
 Hold the radio in a vertical position with the microphone 3-5 cm
from your mouth and then speak.
 When you finish speaking, release the PTT key and a beep
tone will be heard.
5. LISTEN TO OTHER RADIO
 The radio will automatically sound received signal from the
other radio with the same channel and LCD shows the icon
.
 When you press the PTT key, you can’t listen to other radios.
Make sure you do not press PTT key for listening.
 Adjust volume control if necessary.
6. ADJUSTING SPEAKER VOLUME (5 LEVELS)
 Press the Up key
to increase the volume.
 Press the Down key to decrease the volume.
7. TALK TIME-OUT FUNCTION
 Time-out function can avoid transmitting by chance and prolong
the battery life.
 The radio will stop transmitting and sound a warning tone when
PTT is held over 3 minutes. You then need to release PTT
and press again for further transmission.
 In VOX mode, the unit will stop transmitting and sound a
warning tone after continuous talk for 3 minutes. You can
re-activate VOX after the time-out. (Please refer to VOX
function for detailed VOX operation).
8. MENU FLOW CHART
Press Menu key
once to enter main channel selection, press
again for next function selection etc.
Main Screen → Main Channel → CTCSS → Dual Watch → VOX →
Call Tone → Beep Tone → Roger Beep → Auto Power Off → Main
Screen
9. SELECT CHANNEL
To select the main channel
 Press the
key once, Main channel number displayed will
flash.
 Press
or key to select your desired main channel
number.
 Press the PTT key to confirm and quit or press
to continue
next function setting.
 You have 10 seconds to decide before auto-reverting back to