FPDN10A Operation manual Battery Charger and headphone jack Channel Selector Volume Control PTT Mic Speaker Cap Battery Charger and headphone jack Power Switch
FPDN10A Operation manual Belt 1. Basic Operation ■ Power Switch Press power switch the unit will be turn on/off, you can hear the turn on message automatically to indicate that transceiver is power on. ■ Volume Control Press the Volume Control button you can hear the sound level from 1 to 8 . Then adjust the Volume control knob to set the proper sound level. ■ Channel Selector To select channel, press the Channel Selector you can hear the channel from 1 to 16 to set the desired channel.
FPDN10A Operation manual You can charge battery or use headphone jack to listen ■ Speaker Cap Put into the speaker cap you can hear the sound not need use earphone ■ Low Battery Alert If battery is very low level, Battery low alert will be generated to indicate that you need to charge the battery. THE FCC WANTS YOU TO KNOW Your intercom might cause TV or radio interference even when it is operating properly.
This radio has been tested and complies with the FCC RF exposure limits for “General population.” In addition, your SAMCOM radio complies with the following Standards and Guidelines with regard to RF energy and electromagnetic energy levels and evaluation of such levels for exposure to humans: KDB 865664 D01 SAR Measurement 100 MHz to 6 GHz v01r03, Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields. • American National Standards Institute (C95.
this radio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this radio. • DO NOT transmit for more than 50% of total radio use time (“50% duty cycle”). Transmitting more than 50% of the time can cause FCC RF exposure compliance requirements to be exceeded. The radio is transmitting when the “TX indicator” lights red. You can cause the radio to transmit by pressing the “PTT” switch.