User's Manual

②DMX Terminator

ln DMX control mode, the DMX output of the last light fixture should be connected with a DMX terminator

(not included). The terminator is connected with a 120Ω(OHM) resistor across Pin 2 and Pin 3 (As shown below).

This prevents interference caused by DMX signals in the transmitting process.

DMX Terminator Connection

Connect a 120Ω(OHM) resistor

across Pin 2 and Pin 3 in an XLR

plug and insert into the DMX OUT

socket on the last unit.

③Address Setting of the Light Fixtutre.

④Refer to the DMX reference guide and control the light via DMX/RDM console. (For detailed operation please

refer to the DMX/RDM console operation manual.)

Note: DMX reference guide "Forza 150B_REFERENCE_GUIDE_EN" is downloadable from www.nanlite.com.

120Ω

Please scan the QR to check and download the latest DMX reference guide.

PIN 2 PIN 3