User's Manual

!
Attention: Make sure that the aircraft is set on a flat and still surface for the initialization detection.
MEW4-1 User Manual
● Keep pressing the red button “ ” and turn on the remote controller (Pic. 1). The remote controller makes 2 beep sounds, and the
indicator light “ ” keeps flashing; the remote controller is under signal connection status.
● Power on the aircraft (Pic. 2). The aircraft will make beep sounds with rear light flashing and will automatically link to the remote controller.
Once the remote controller sends out a long beep sound and the indicator light of the remote controller turns from flashing to solid on and
the signal icon “ ” is shown on the LCD screen, it means that signal connection is succeeded.
Aircraft initialization detection
After signal connection, the aircraft enters into initialization detection procedure with rear light flashing red, green and yellow alternatively.
Make sure that the aircraft is set on a flat and still surface for the initialization detection. The aircraft initialization detection takes about 8
seconds. Once the remote controller sends out “Di Di” sounds and the aircraft rear light flashes yellow, initialization detection is completed.
!
● Signal connection is done once for all if the remote controller is not linked to other aircraft.
● Set the connection one by one to avoid signal connection error.
Signal connection between the aircraft and remote controller
Aircraft Operations
Pic. 1 Pic. 2
-22-