User Manual


7

TVsetbyusingtheRCAto3.5mmplugaudiocablecordsupplied.
Preparations
CAUTION:
The valid operation range between the headset and
transmitteris5minopenarea.

1.Get connected. Connect  the transmitter to your TV set by the provided audio cable,
makesurethatthecolorofRCAplugsarematchedthecolorofsocket.
Tips:ItisconvenienttoplacethetransmitternearyourTVset.
2.
Fully extend the DC cord, and keep the DC cord lie vertically (up or down), as the DC
cordactsasasignaltransmissionantenna.


3.
Take the battery packs from the packing then insert one of the battery pack into the
headsetbase,withtheengravedsymbolsidefacingupward.

NOTE: The battery pack carries a little power and it is adequate for searching an idle
FMfrequency.However,itisbettertochargethebatterypackatleast 8hoursbefor e
first use. (For detailed information of charging the battery pack, please refer to
“Chargingthebatterypack”.)