User's Manual
GETTING STARTED
CONNECTING THE EXTERNAL SPEAKERS
The speaker input sockets are located at the back of the main unit.
<U^YHW[OLZWLHRLY^PYLMYVT[OLSLM[ZWLHRLYHUKWS\NP[PU[V[OLSLM[3
speaker socket on the main unit.
<U^YHW[OLZWLHRLY^PYLMYVT[OLYPNO[ZWLHRLYHUKWS\NP[PU[V[OLYPNO[9
speaker socket on the main unit.
3. Make sure the speaker cables are n ot run in areas where they could cause
danger.
PRELIMINARY
Before using your audio system, the protective packing should b e r emoved from the
CD c ompartment. To r emove the protective packing:
1. Press the EJECT/ENTER button to the right of the CD door to open the CD door.
2. Remove the protective packing from the CD c ompartment.
3. Close the CD door by pressing the EJECT/ENTER button again.
FM A ntenna
Unwrap the FM antenna and extend it fully. Yo u may need t o a djust the p osition of
the antenna to g et
optimum reception.
Connecting to a P ower Source
1. Check that the mains voltage on the rating plate on the back of the main unit is
the same as the v oltage in your area.
2. Plug the electric plug into the wall s ocket. The CD Stereo S
ystem is now ready
for use.
Standby Control
Press the POWER button to turn the unit ON. Press again to turn the unit OFF.
56;,!>OLUSLH]PUN[OL\UP[\UH[[LUKLKMVYSVUNWLYPVKZZ\JOHZ]HJH[PVUZ
please disconnect the p ower plug from the mains supply.
LISTENING TO THE RADIO
1. Press the FUNCTION BUTTON t o switch to the FM RADIO. The display will
show a radio station: “87.5”.
2. Tune t o a desired radio station. The frequency is indicated on the display.
MANUAL TUNING: Pr
ess the TUN+ or TUN-I\[[VUIYPLÅ`HUK[OLMYLX\LUJ`
will tune up or down.
AUTO SEARCHING: Press the TUN+ or TUN- button for more than 2
seconds, the radio frequency will start to change on the display. Once a
station is found, the radio will
stop searching and start to broadcast
immediately.
3. Re-position the antenna if necessary.
5