User Manual

6
Directions for use
3. Feed clean water into the water tank.
Way to configure WiFi network
Scan the following QR code to download the APP and install it to your mobile
phone as instructed on the mobile phone.
4. Mount the water tank and the mop holder into the main body in sequence.
5. Long press button“ ” for 3s to power on the Product. After that, short press
button“ ”. The Product will then be recharged automatically. Upon full recharge,
it will be ready for work.
Binding a Android
mobile phone number
to the WiFi Click the wanted
connectable object, connect
“Next”and operate as instructed
on the mobile phone.
Reset ti ng WiF i
Binding an IOS mobile phone to
WiFi
On the WiFi setting page of the mobile phone,
choose the Product’s hotspot to connect. After
succcessful connection, back to the APP, click “Next”
and connect as instructed.
Note: If the connection fails, operate as below with
reference to the content of “Way to reset WiFi”.
Please connect to the WiFi network for better
experience of use.
After the router has been replaced, or the WiFi network password has been changed, the WiFi
function needs to be reset: press buttons “ ” and“ ”at the same time for 5s. If the WiFi
indicator is flashing slowly in blue, and there is a voice prompt, it suggests successful WiFi
reset.
1 . 2 m
0 . 5 m
0 . 5 m
Caution:
1. After working for more than 1 minute, the Product will return to the dust collector and remove the dust
in the dust container automatically.
2. The Product may fail to be powered on when ithas a low battery. Please fully charge it before use.
3. If the Product has a low battery in sweeping, it will return to the dust collector automatically for
recharge. After recharge, it will return to the position where it paused automatically to continue with
the sweeping.