Instruction Manual

Please clean the rolling brush kit every week.
Rolling Brush
The universal wheel and anti-fall sensors on the bottom of the robot
must be regularly cleaned with a soft cloth. Never let the sensors get
wet.
Sensors and Wheels
Anti-Fall Sensors
Universal Wheel
Anti-fall Sensors
Specification
ClassificationSpecificationValue
Dimension
Electronic
Cleaning
Diameter
Height
Weight
Voltage
Battery Capacity
Dust Bin Capacity
Water Tank Capacity
Charge Type
Cleaning Type
Charge Duration
Cleaning Duration
Mop Duration
Manual/ Auto re-charge
Auto / Max / Mode / Schedule
Operation Touch Panel Operation
Hours
Minutes
Minutes
Note: the specification could be modified with the objective
continual improvement.
Troubleshooting & Solution
Voice DemonstrateSolution
Please turn on the power switch
Please charge
Left front bumper fault
Wheel overload
Side brush overload
Rolling brush overload
Switch on the robot
Put the robot onto the charge station
1, the robot off the floor, please put the robot onto floor
2, the anti-fall sensor may dirty, please clean with cloth
3, the sensor may send false alarm, please restart the robot
Check the bumper if it spring back correct
Check if foreign body winded the wheels, and remove it
Check if foreign body winded the side brush, and remove it
Check if foreign body winded the rolling brush, and remove it
Troubleshooting
!Attention:
If above solution not work, please try:
1.restart the robot vacuum cleaner
2.contact our customer service center: [e-mail]
for after sale service.
Please put the machine in a safe
place