Quick Reference Guide

Quick Reference Guide
6 Set Power Dialogue
Depending on the environment and the RFID tag in use, you need to adjust the power setting
of the reader's amplifier to read and write successfully.
6.1 To set the power level
• Select “Settings->Set Power” from the top menu bar
• Use the slide bar to set the power level
• Click on “OK”
Output power range:
Min = 10 dbm
Max = 30 dbm
Stepping = 1 dbm
GTSYS LTD. R07 9/F Kwai Shing Ind. Bld Phase 2, 42-46 Tai Lin Pai Road, Kwai Chung, HONG KONG SAR – Email: [e-mail]
Copyright © 2020 GTSYS – GTSYS reserves the right to change specifications without prior notice Page 11 / 11
Notice: High power values can have a negative effect to the read/write results – it is recommend to
start from low (min) to high (max) power values in small steps to find the optimal setting.
Illustration 7: Set Power Dialogue