User's Manual


2001-05-07


1
11
1
1
11
1
.
..
.
.
..
.
S
SS
S
S
SS
S
u
uu
u
u
uu
u
m
mm
m
m
mm
m
m
mm
m
m
mm
m
a
aa
a
a
aa
a
r
rr
r
r
rr
r
y
yy
y
y
yy
y
This section describes DotSurfer PCMCIA card user manual for Linux based laptops.
Need the following in order to use DotSurfer Card:
- Linux Kernel 2.2 or higher
- Basic Module and setup needed to use PCMCIA Card
- setserial 2.17 or higher
This document does not explain the basic items regarding how to use a PCMCIA card in
the laptop nor does Gtran Korea provide technical support regarding this. However, you
should not worry. Most of the current Linux Package take PCMCIA users into
consideration. Unless under a special condition, you should be able to easily use PCMCIA
slot. Incase of difficulties, refer to resources such as PCMCIA-HOWTO.
You can confirm the user’s setserial version as a below
setserial
setserial setserial
setserial –V
VV
V
Use capital V for option. If version is lower than 2.17, use setserial command without
option and verify whether you can use 16950, 16954 which is listed under uart option. If
they are not listed under the option list, current setserial being used should be upgraded
to the newest version.
You can get the newest version of setserial package from http://sourceforge.net/
.
CD provided for user’s convenience includes setserial-2.17.tar.gz file.